【 Student Question 】 Safety operation rules of steel bar cutting machine?

1. The mechanical operation is normal, prevent the cutting off of the material, the distance between the hand and the knife edge shall not be less than 15 cm, and the feeding is prohibited when the active blade is moving forward.

2. Cutting steel bars do not exceed the mechanical load capacity, cut special steel bars such as low alloy, and use high hardness blades.

3. The length of the steel bar should be assisted by special personnel, and the action should be consistent during operation, and should not be dragged arbitrarily; When cutting rebar, it is necessary to use sleeve and pliers to clamp the material, and it is not allowed to feed the material directly by hand.

4. The cutting machine should be set up next to the feeding table, the mechanical operation is strictly prohibited to use the hand to directly remove the short head and debris near the knife edge, in the steel bar swing range and near the knife edge, non-operators shall not stay.

5. Install a reliable and effective grounding device as required, and the conductor is well insulated.

The above contents are organized according to the problems encountered in the actual work of the students, for reference, if there is a problem, please communicate in time and correct.